Vauxhall Corsa-D Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hey guys,

So I’ve had this intermittent fault for a while now where occasionally my blowers won’t put out any air at all, it used to happen occasionally but recently it’s been non stop. I pulled the motor out and it looked fine and then pulled out the resistor and found the connector was badly worn, two of the pins were black and part of the insulation was split on one of the cables. I’m guessing this is what’s been causing my blowers to play up but now I’m wondering what caused it? Could it just be general wear? Also how would I go about changing this plug? Is it crimped or soldered? I’ve attached some pictures to help. Cheers.
19897
19898
19899
 
1 - 1 of 1 Posts
Top